MS Digi Doser Di-O 2, 110V

Digi Doser Di-O 2 is a dosing system to add Di-O-Clean into the drinking water system. The system is equipped with a digital membrane pump, that doses the right amount of Di-O-Clean in the water pipe based on the pulses of the water meter.

The Digi Doser is delivered in plug & play modules. These modules are easy to mount on the stainless steel back plate, by using the included instruction card.

• Easy to operate
• Equipped with a float system with warning when empty
• Specially developed to dose low doses in a precise way
• Made of special materials that are resistant to chlorinedioxide

• Mount the pump as close as possible after entering the source and tap water. In this way, the entire drinking water system can be cleaned and disinfected as completely as possible
• Create a by-pass, so the drinking water system can also be used during an defect or malfunction at any time
• If the supply water contains (a little) dirt, install a water filter in front of the dosing system. This will avert water meter faults
• In case of doubt about the flow capacity, water pressure or dosage, our employees are ready to advise you
• Upon startup or replacement of parts, the Digi Doser must be calibrated

• Throughput capacity: 15 - 2,500 l/hour
• Water pressure: 0.05 - 5 bar
• Dosage: 20 - 1080 ppm
• Max. pump capacity: 2.7 l/hour
• Water meter pulses: 2 p/litre
• Input and output connections: PVC 40 mm – 40 mm